5
FP288 (07-14-20)
TROUBLESHOOTING
** If motor fails, replace entire pump.
• Not Illustrated.
5
SPECIFICATIONS
REF DESCRIPTION QTY PART NO.
5 Power Cord 1 PS117-54-TSU
•
Garden Hose
Adapter
1 FT0013-43
SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION
Pump won’t start or run
Blown fuse If blown, replace with fuse of proper size.
Low line voltage
If voltage under recommended minimum, check size of
wiring from main switch on property. If OK, contact
power company.
Defective motor Replace pump.
Impeller
If impeller won’t turn, for models FP0S1300X and
FP0S1600X, remove the screen. Locate the source
of binding.
Pump operates but delivers
little or no water
Low line voltage
When an extension cord is necessary use as short of a
cord as possible. Use only 14 gauge or larger
extension cords.
Something caught in impeller Clean out impeller.
Small diameter garden hose
or long discharge line
Use larger diameter garden or 1” exible pipe. Eliminate
any excess hose. Short hoses work best.
Air lock
Turn off pump for a few seconds, clean out anti-airlock
hole and restart pump.
Coils or bends in hose Straighten hose.
To Next Page
Loading...
Need help?
General
