09931286E
7
Rear View of Peltier Controller
Figure 6 Rear view
a. RS-232 port
b. AC Power: Main Power ON/OFF
c. Fuse: AC socket + Fuse Holder
d. Interface: Interface cable for connecting with 6-Position Peltier Controlled Cell Changer
e. Air Vent Manual button: It is used for removing the air in the coolant hose.
f. Buzzer: It makes an alarm sound. If there is any problem before the measurement, Buzzer
beeps 6 times at every 10 sec. If the malfunction occurs during the operation, Buzzer beeps
twice at every 10 sec.
g. Quick Coupler of Coolant lnlet/Outlet
h. Quick Coupler of Coolant Drain
i. N
2
Gas Inlet/Outlet ports
NOTE:
N
2
gas is not always required [Tube for N
2
gas is not supplied with the accessory].
j. Flow Gauge: Indicator of the flow rate of N
2
gas.
To Next Page
Loading...
Need help?
General
