9
Operation & Installation Manual
Signature Series Beer Dispensers (HP15, HP24 and HP48 models)
ANTI-TIP BRACKETS
WARNING
Unit may tip forward if loaded racks/shelves are all pulled
out at the same time. To prevent tipping and provide a stable
installation, the unit must be secured in place with the anti-tip
brackets provided with the unit.
A set of metal anti-tip brackets and necessary hardware is supplied
with the unit. The anti-tip brackets, when properly installed, should
secure the rear legs and prevent the unit from tipping forward.
Some installation sites may require modication to provide a secure
surface for attaching brackets. Refer to Figures 5 and 6 (right) and
Figure 7 (below) for mounting bracket locations for 15”, 24” and 48”
Signature Series models.
IMPORTANT NOTE: If installing on a concrete oor, concrete
fasteners are required and are not included in the Anti-Tip Kit.
Figure 7 - 48” Anti-Tip Kit Drawing
Figure 6 - 24” Anti-Tip Kit Drawing
15
16
"
13
1
32
"
3
16
"
3
8
"
ANTI-TIP BRACKET
PART #63740
Figure 5 - 24” Anti-Tip Kit Drawing
To Next Page
Loading...
Need help?
General
