PERLICK RESIDENTIAL INSTALLATION MANUAL
12
perlick.com
WOOD OVERLAY INSTALLATION
(FOR -2, -4 AND -6 MODELS)
Before beginning installation, check all components for
proper t and nish. Handle should be installed to the
overlay prior to installing overlay to door (use countersunk
athead fasteners for handle installation.)
For best performance and
functionality, the overlay panels
should be 3/4” thick. The weight of the overlays should
not exceed 20 lbs for solid (-2) doors, 10 lbs for glass
(-4) doors, or 10 lbs for drawer (-6) models.
1. -2, -4 and -6 models come ready to accept wood
overlay as shown below.
2. Remove the gasket carefully starting at the corners and
avoid ripping the dart.
3. In some cases, the dart on the gasket may rip. If this
happens, replace with a new gasket.
4. With the gasket removed, the screw holes needed to
hold the overlay panel will be reveal as shown below.
To Next Page
Loading...
Need help?
General
