7
A
A
Presser foot lift
Raise the presser foot with the presser foot lift lever (A) at the
back of the machine.
Changing the needles
Turn off the main power switch and unplug the machine.
1. Turn the hand wheel toward you until the needles are at the
highest position.
2. Loosen, but do not remove the left (B) and/or right (A)
needle clamp screw with the small screwdriver while you
are holding the needles.
3. Remove the left and/or right needle.
4. Hold the new needle/s with the Á at surface to the back.
2. Insert the needle/s into the left and/or right needle clamp
as far as it will go.
3. Securely tighten the left (B) and/or right (A) needle clamp
screw.
Changing the presser foot
Turn off the main power switch and unplug the machine.
1. Raise the presser foot.
2. Turn the hand wheel toward you until the needles are in the
highest position.
3. Push the white button on the back of the presser foot bar
(A), and the foot will come off.
4. Place the new foot with the pin right underneath the groove
of the ankle and lower the presser foot. Push the white
button on the back of the presser foot bar (A) and the foot
will snap into place.
To Next Page
Loading...
Need help?
General
