10
2 Fill the water tank with tap water up to the MAX indication.
Note: Do not ll the water tank beyond the MAX indication to avoid spillage.
If you have overlled the water tank, empty it until the water level drops
below the MAX indication again.
3 Put the water tank back into the appliance by sliding in the bottom
part rst. Then push the top part until it locks into place.
Tip:. Your appliance has been designed to be used with tap water. In case
you live in an area with hard water, fast scale build-up may occur. Therefore,
it is recommended to use distilled or demineralised water to prolong the
lifetime of your appliance.
Do not use perfumed water, water from the tumble dryer, vinegar,
starch, descaling agents, ironing aids, chemically descaled water or
other chemicals, as they may cause water spitting, brown staining or
damage to your appliance.
Note: Do not tilt or shake the appliance when the water tank is full,
otherwise water may spill out of the lling hole.
Heating up
1 Put the plug in an earthed wall socket.
2 Press the on/off button to switch on the appliance.
ENGLISH
To Next Page
Loading...
Need help?
General