Pioneer A-402 User Manual

OPERATIONS
COPYING TAPES
When two decks are used, you can record the sounds from one deck
onto the other.
Application examples: a ——
© To make a tape copy with contents identical to the original tape. a cocoon
@ To edit a recording of an FM broadcast in order to cut out unwanted
commercials, recording only desired material onto another tape.
When using two cassette decks
1. Load tapes for playback (pre-recorded tape) and
recording (blank tape) into the respective
cassette decks.
2. Select the copying direction with REC SELECTOR
switch.
e When copying from the cassette deck of TAPE 1/DAT terminals
to the cassette deck of TAPE 2 terminals: Set to 1 > 2.
@ When copying from the cassette deck of TAPE 2 terminals to the
cassette deck of TAPE 1/DAT terminals: Set to 2 > 1.
NOTE:
The tape input selected with REC SELECTOR switch can be copied, TAPE 2
regardless of the settings of INPUT SELECTOR and DIRECT switches. Q a
eel
3. Operate the cassette decks to begin copying. 1
Set the cassette deck with the pre-recorded tape to the playback
mode. Set the cassette deck with the blank tape to the recording
mode, and set the cassette deck with the pre-recorded tape to the
playback mode.
Playback using a graphic equalizer
The sound of all sources can be finely adjusted with a graphic
equalizer connected to ADAPTOR terminals.
However, the graphic equalizer is bypassed when DIRECT switch is on.
NOTE:
Be sure to perform this operation with the adaptor component power
switch in the on position. Even when not using the adaptor
component, its power switch must be left on. If the adaptor
component is switched off, no sound will be produced, or the
playback sound will be distorted.
9
<ARB1433>

Pioneer A-402 Specifications

General

Brand	Pioneer
Model	A-402
Category	Amplifier
Language	English