Listening to your system05
36
En
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the input select buttons (
INPUT
SELECTOR
).
4 Start playback of the component you
selected in step 1.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 14), you must select the analog
multichannel inputs for surround sound play-
back.
1
1 Press
DVD 5.1 CH
on the remote control
or DVD 5.1 on the front panel.
To cancel playback from the multichannel
inputs, use the
INPUT SELECTOR
buttons to
select a different input signal.
Using the sleep timer
The sleep timer switches the receiver into
standby after a specified amount of time so you
can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
• Press
SLEEP
repeatedly to set the sleep
time.
Tip
• You can check the remaining sleep time at
any time by pressing
SLEEP
once. Pressing
repeatedly will cycle through the sleep
options again.
• You can also switch off the sleep timer
simply by switching off the receiver.
Note
1• When playback from the multichannel inputs is selected, you can’t use
INPUT ATT
,
TONE
,
DIALOG E
,
VSB
and
MIDNIGHT/
LOUDNESS
, as well as the
STANDARD
,
ADVANCED SURROUND
,
STEREO/DIRECT
and the
AUTO SURR.
sound modes.
• When playback from the multichannel inputs is selected, only the volume and channel levels can be set.
INPUT SELECTOR
RECEIVER
CD-R/
TAPE/MD
SLEEP
DVD/LD
CD FM AM
TV/SAT DVR/VCR
DVD 5.1CH
FL DIMMER
INPUT ATT
INPUT SELECTOR
RECEIVER
CD-R/
TAPE/MD
MIDNIGHT/
LOUDNESS
ADVANCED
SURROUND
STANDARD
STEREO
SLEEP
DVD/LD
CD FM AM
TV/SAT DVR/VCR
DVD 5.1CH
FL DIMMER
INPUT ATT
INPUT SELECTOR
RECEIVER
SLEEP
FL DIMMER
INPUT ATT
Off
90 min 60 min
30 min
VSX_415-515.fm 36 ページ ２００４年１２月８日 水曜日 午後３時１２分
To Next Page
Loading...
Need help?
General