62
OPERATION
Track Warm- Up
WARNING
A loose track or flying debris could cause serious injury or death.
Stand clear of the front of the machine and the moving track.
Never hold the snowmobile up or stand behind it while warming
up the track. Do not use excessive throttle during warm-up or
when the track is free-hanging. Use a stable rear support.
WARNING
Use of traction products such as studs, ice growsers, etc. will
increase the possibility of track damage and/or failure. This could
cause loss of control, resulting in serious injury or death. Always
inspect for track damage before operating the snowmobile.
Follow these steps to ensure proper
warm-up of the engine, drive train and
track.
1. Use an appropriate stand to
securely support the rear of the
snowmobile at the rear bumper.
The track should be about 4″ (10 cm)
off the ground.
2. Start the engine and allow it t o warm up
two to three minutes.
3. Depress the throttle abruptly and allow the track to rotate several
revolutions.
NOTE: It will take longer to warm up the track sufficiently during
colder outdoor temperatures.
4. Release t he throttle, apply the brakes, shut off the engine and lower
the machine to the ground.
5. Grasp the skis by their front loops and move them from side to side
to loosen snow and ice.
Slide Rail and Track Cooling
CAUTION
Inadequate cooling and lubrication will lead to overheating of the
slide rail and track, resulting in premature wear and failure.
Reduce speeds and frequently drive into fresh snow to allow
adequate cooling and polishing of the slide rail and track
surfaces. Avoid operating on ice, hard-packed surfaces or roads.