67
OPERATION
n Engine Stop Switch
Push down on the engine stop
switch (A) to ground out the
ignition and stop the engine
quickly. Pull the switch up t o the
ON position to allow restarting.
n Throttle Safety Switch
The throttle safety switch is designed to stop the engine whenever all
pressure is removed from the throttle lever and the throttle cable or
valves do not return to the normal closed position.
WARNING
Operating the snowmobile with a faulty throttle safety switch can
result in serious injury or death in the event of an accident. If the
throttle safety switch does not shut off the engine during a throttle
system malfunction, immediately push down the engine stop
switch. Do not start the engine again until the malfunction has
been corrected by your dealer.
Test the t hrottle safety switch
system daily before operation.
1. S it on the seat.
2. Start the engine and allow it t o
idle.
3. Hold the throttle lever pin
stationary by exerting pressure
on the pivot pin in the direction
shown in the illustration (B).
4. Apply a slight amount of throttle. A properly functioning switch
must shut down the engine.
A
B
To Next Page
Loading...
Need help?
General
