115
MAINTENANCE
Lights
Headlight and taillight lenses become dirty during normal operation.
Clean all lights frequently to ensure a clear field of vision as well as vis-
ibility to other vehicles.
Tip: If an LED headlamp has moisture or fogging inside, disconnect the wiring
harness from the headlamp(s) for a few days to allow the moisture to clear
out. Do not operate the vehicle at night or in low light conditions without
properly working headlights.
Brake Lights
When the brake pedal is depressed, the brake light comes on. Check the
brake light before each ride.
1. Turn the ignition switch to the ON position.
2. Apply the brakes. The brake light should come on after about 10
mm (0.4 in.) of pedal travel. If the light doesn't come on, check the
bulb.
Headlight Replacement
If a headlight becomes damaged or
inoperable, the entire headlight
assembly must be replaced. Do not
operate this vehicle at night or in
low light conditions until the
headlight is replaced. Always make
sure lights are adjusted properly for
best visibility.
Headlight Rear View
To Next Page
Loading...
Need help?
General
