OPERATION
STARTING THE ENGINE
q
FULL CHOKE
w
1/2 CHOKE
e
OFF
CAUTION
Engaging the starter when the engine is running WILL result in serious engine
damage, especially if the transmission is in reverse. Never engage the starter
when the engine is running.
1. Turn the fuel valve on. See page 60.
2. Turn the key to the ON position
3. Pull the engine stop switch up to the RUN position.
4. If starting a cold engine, flip the choke toggle to FULL CHOKE. Do not use
the choke if starting a warm engine. Do not depress the throttle until the
engine starts.
CAUTION
To avoid injury and/or engine damage, do not operate the electric starter or
pull-rope starter while the engine is running.
NOTICE
Don’t pull the starter rope to the fully extended position and don’t allow it to
snap back into the housing. Damage may result.
5. If equipped with electric start, turn the key to START to crank the engine.
Release the key to the ON position when the engine starts.
6. If not equipped with electric start, grasp starter handle and pull slowly until
the recoil engages, then pull abruptly to crank the engine.
7. Repeat the cranking procedure as needed until the engine starts.
55
OPERATION
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
