To Next PageTo Next PageTo Previous PageTo Previous Page
Why does my Polaris 550 Shift 136 engine lack power?
If your Polaris Snowmobile engine lacks power, several factors could be at play. Start by replacing fouled or defective spark plugs. If the issue persists, check the fuel filter flow; it should be steady and encompass the entire diameter of the fuel line when disconnected. If not, replace the filter.
What to do if my Polaris Snowmobiles engine turns but fails to start?
If your Polaris Snowmobiles engine turns but fails to start, there are several things to check. First, install new spark plugs. If that doesn't work, ensure the fuel valve is on and the fuel tank contains fuel. Try using the choke. If ice may be in the fuel line, filter, or pump, add isopropyl alcohol to the fuel system. If the engine is flooded, hold the throttle open and crank the engine several times. Note that on the standard Polaris carburetor, the choke will not function with the throttle depressed.
How to troubleshoot noise in the drive system of Polaris Snowmobiles?
If you notice noise in the drive system of your Polaris Snowmobiles, inspect the drive belt for flat spots and replace it if needed. Also, check the drive chain for looseness and adjust or replace it as necessary.
What causes a Polaris Snowmobiles engine to continually backfire?
If your Polaris Snowmobiles engine continually backfires, start by changing the spark plugs. Additionally, check the fuel system for dirt or ice; if present, add deicer to non-ethanol fuel.
Why is the drive clutch engagement harsh on my Polaris 550 Shift 136?
A harsh drive clutch engagement in your Polaris Snowmobiles can be due to a worn or too narrow drive belt. Replacing the drive belt may resolve this issue.
How to improve poor low RPM performance on Polaris 550 Shift 136 Snowmobiles?
Poor low RPM performance in your Polaris Snowmobiles can stem from several causes. Begin by inspecting the drive belt for wear and replace it if necessary. Then, check the torque stop for looseness and adjust it accordingly.
What causes the drive belt to turn over on Polaris 550 Shift 136 Snowmobiles?
If the drive belt turns over on your Polaris Snowmobiles, it might be the wrong belt for the application. Replacing the drive belt with the correct one may solve the problem.
Why does my Polaris 550 Shift 136 engine require more pulls to start than usual?
If your Polaris Snowmobiles engine requires more than normal pulls to start, it could be due to poor fuel quality. Try replacing the fuel with fresh winter fuel.
What to do if my Polaris Snowmobiles machine fails to move?
If your Polaris Snowmobiles fails to move, a foreign object may be caught in the track, or the rail slide melted to the track clips due to lack of lubrication. The track may also be iced up or frozen to the ground.
Why is the steering heavy on my Polaris Snowmobiles?
To address heavy steering on your Polaris Snowmobiles, ensure the spindles and all steering components turn freely. Also, check the ski alignment, skags and skis for damage and set static sag.
General| Engine Type | 4-Stroke |
|---|---|
| Engine Displacement | 544 cc |
| Cylinders | 2 |
| Track Length | 136 inches |
| Track Width | 15 inches |
| Brake Type | Hydraulic Disc |
| Seating Capacity | 1 |
| Front Suspension | Independent |
| Rear Suspension | RydeFX MPV Shocks |
| Fuel System | EFI |
