109
MAINTENANCE
Camber and Caster
The camber and caster are non-adjustable.
Front and Rear Springs
The front and rear shock absorber
springs are adjusted by rotating the
adjuster either clockwise or counter-
clockwise to increase or decrease
spring tension. Accessory springs
are available through your
POLARIS dealer.
Handlebars
The handlebars can be adjusted for rider preference.
WARNING! Improper adjustment of the handlebars or incorrect torquing of the
adjuster block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control and serious injury or death. Follow the
adjustment procedures exactly, or see your POLARIS dealer for service.
1. Remove the upper headlight
pod.
2. Loosen the four handlebar
bolts.
3. Adjust the handlebar to the
desired height. Be sure the
handlebars do not contact the
gas tank or any other part of
the machine when turned fully
to the left or right.
4. Torque the front two bolts to
10-12 ft. lbs. (14-17 Nm), then
torque the rear two bolts. A
gap of up to 1/8" (3 mm) will
remain at the rear of the clamp
blocks.
To Next Page
Loading...
Need help?
General
