39
FEATURES
Instrument Cluster
Rider Information Center
Security System (Ignition Lock System)
First Time Use of Your Security System
TASK 3: Unlock the System
1. When the engine is running, the display will
alternate between SECURE ON and
ENTER CODE. Wait until ENTER CODE
displays, then press and release SEL to
advance the digit. When “0” is displayed,
press and release MODE to accept the
digit.
2. Press and release SEL to advance the second
digit. When “0” is displayed, press and release
MODE to accept the digit.
3. Press and release SEL to advance the third digit.
When “0” is displayed, press and release MODE
to accept the digit.
4. After accepting the third digit, view the display
screen. SECURE OFF displays if the system
unlocks.
NOTE: The system is now unlocked.
5. You must now enter a new security code. Proceed immediately to TASK 4.
TASK 4: Enter Your New Security Code
1. Immediately after locking and unlocking the system, and while SECURE
OFF is displayed, press and release the MODE button to bring up the
ENTER CODE screen.
2. When ENTER CODE displays, use the SEL and MODE buttons to select
and accept each digit of a new personal security code.
3. After accepting the third digit, view the display
screen. The new code and CODE SET will dis-
play if the system accepted your new code. You
will not see this display again.
NOTE: Your new code is now set. The system is
NOT locked.
4. Record your new security code in a safe place for future reference.
Record your new personal security code here: __________________
TIP:If you lose your personal security code, see your dealer to have the code
reset to “000”. Then perform TASK 2 through TASK 4 to change the code
to one of your own choosing.
To Next Page
Loading...
Need help?
General
