121
MAINTENANCE
Lights
The headlight and taillight assemblies feature LED elements and are not
serviceable. If an LED fails to illuminate in either the headlight or
taillight, the entire assembly must be replaced. Please see your
POLARIS dealer.
Fuse Replacement
The brake system and ACC 2-amp fuses are located in the protective
bag above the clutch cover.
NOTICE: Always replace a blown fuse with a new fuse having the same
amperage rating of the blown fuse. Never replace a fuse with a fuse of
a higher amperage rating.
Constant Power Fuse
Models equipped with electric start have a battery/electric start wire
harness. The 2 amp constant power fuse is located in the electric start
wiring harness.
This fuse protects KEY ON power at the ignition switch. KEY ON
power supplies battery voltage to the IDD and GPS puck.
If the IDD does not turn on when the key is in the ON position, check
for a blown fuse. If the fuse is blown, inspect the constant power circuit.
Repair or replace any damaged components before replacing the fuse.
To Next Page
Loading...
Need help?
General
