81
OPERATION
Auxiliary Engine Stop Switch
Push the auxiliary engine
stop switch down to ground
out the ignition and stop the
engine quickly. Pull the
switch up to the RUN
position to allow restarting.
Throttle Release Switch
The throttle release switch is designed to stop the engine if all pressure
is removed from the throttle lever and the throttle cable or throttle plates
do not return to the normal closed position.
WARNING! Operating the snowmobile with a faulty throttle release switch can
result in serious injury or death in the event of an accident. If the throttle release
switch does not shut off the engine during a throttle system malfunction,
immediately push down the auxiliary engine stop switch. Do not start the engine
again until the malfunction has been corrected by your dealer.
Test the throttle release switch system daily before operation.
1. Sit on the seat.
2. Start the engine and allow
it to idle.
3. Press and hold the lever
pivot as shown.
4. While preventing the lever
from pivoting, slightly
push the throttle lever as
shown. A properly
functioning switch must
shut down the engine.
Stop Switch
To Next Page
Loading...
Need help?
General
