Polaris Genesis 2000 User Manual

MAINTENANCE/TUNE UP
Cable Adjustments
Throttle Cable Inspection/Adjustment
Cable Inspection
1. Check for smooth throttle opening and closing in all
handlebar positions. Throttle operation should be
smooth and lever must return freely without binding.
2. Inspect cable for proper routing, kinks, or damage.
3. Inspect both ends of cable and replace if frayed, kinked
or damaged.
Cable Adjustment - SLX / Pro 1200
Adjustments are made by turning the lock nuts at the carbu
retor and then fine tuning at the throttle block adjuster bolt.
1. Set idle speed to specifications. See idle speed
adjustment, page 2.17.
2. Measure throttle lever free play between lever block and
lever as shown in III. 1.
3. To adjust, loosen lock nut on upper throttle cable
adjuster. Turn adjuster in (clockwise) to increase or out
(counterclockwise) to decrease free play.
4. Tighten lock nut securely when adjustment is complete.
5. Start engine and turn handlebars to left and right
through entire turning range. If engine RPM increases
re-check cable condition, routing, and lever free play,
and correct or adjust as necessary.
Cable Adjustment - Virage TX / Genesis / FFI™
1. Set idle speed to specifications. See idle speed
adjustment, page 2.17.
2. Measure throttle lever freeplay between the lever block
and lever as shown in III. 1.
3. To adjust, loosen lock on cable. Turn adjuster in
(clockwise) to increase or out (counterclockwise to
decrease free play. Tighten lock when adjustment is
complete.
Never operate the engine for more than 15 seconds without
cooling water. Severe engine damage may occur from over
heating.
Throttle Lever Free Play
.020 -.060" (.5 -1.5 mm)
.020-.060" (.5-1.5 mm)
11.1.
Adjuster Lock Nut
Polaris Sales Inc.
2.19
3/00

Polaris Genesis 2000 Specifications

General

Brand	Polaris
Model	Genesis 2000
Category	Boat
Language	English