Polaris Genesis 2000 User Manual

MAINTENANCE/TUNE UP
Cable Adjustment/Fuel System
Reverse Cable Adjustment
The reverse cable does not require periodic adjustment.
If the reverse linkage does not function properly, inspect
the cable for damage. Inspect all linkage, fasteners,
brackets, and pivots for wear or damage. When a new
cable is installed the cable must be adjusted.
1. Place reverse shift lever in reverse position.
2. Loosen cable adjuster nuts.
3. Adjust cable until reverse gate locating collars
engage fully into reverse actuator locating slot when
slight upward pressure is applied to reverse gate.
Reverse gate must float in the notch and should not
be forced in.
4. Check gate locking by pulling up on gate when in
down position.
5. Move shift lever to forward position. Reverse gate
must be above water stream.
6. Tighten adjuster nuts securely.
7. Seal the cable threads and adjuster nuts with
marine grade silicone sealant (PN 8560054) and
tighten securely. Allow sealant to cure fully before
operating craft.
Carb Air Intake
1. Remove carburetor air intake cover.
2. Inspect element for damage or debris.
3. Clean with hot water and mild detergent, or replace
element. Rinse thoroughly in clear water.
4. Dry completely and reinstall parts. Torque cover bolt to
specifications found in Engine section.
Torque Properly -
Refer to Engines
Section
Element
Polaris Sales Inc.
2.25
3/00

Polaris Genesis 2000 Specifications

General

Brand	Polaris
Model	Genesis 2000
Category	Boat
Language	English