Page 14
English
Figure 26. Position the New Brush on Roller
4. Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot (see Figure 27).
4
Figure 27. Pull Tabs Through Each Slot
5. Use scissors to cut the tabs so they are no higher
than the spikes (see Figure 28).
Figure 28. Cut Tabs
6. Repeat this procedure to replace the second
brush.
5.3 Replacing the Tracks
1. Stand the cleaner on its side (see Figure 29).
Figure 29. Stand Cleaner on its Side
2. Starting at one of the wheels, pull on the inside
of the track to separate the tire lip from the
wheel (see Figure 30). Remove the track from
the cleaner.
Figure 30. Pull the Track Over Wheels to Remove
3. To install a new track, place the inside rib of
the track into the groove in the rst wheel (see
Figure 31).
Figure 31. Position Track into Wheel Grooves
1
4. Stretch the track around the second wheel, then
pull over the last wheel (see Figure 32). Push
and position the rib of the track so that the track
is seated properly in the groove of the wheel.
To Next Page
Loading...
Need help?
General
