Page 18
English
Problem Cause Solution
Cable is tangling in the pool Too much cable length in the water. Do not unravel the entire cable. Use only the
amount needed for the cleaner to cover the pool
area.
Place the remaining unused cable on the side of
the pool. Follow the procedure in Cord Tangling to
avoid and correct tangled cord.
The cleaner is not cleaning
effectively.
The brushes have become smooth or
the "wear" indicator shows.
Replace the brushes following the procedure in
Replacing the Brushes.
Filter canister is full or dirty. Clean the lter canister following the procedure in
Cleaning the Filter Canister.
Floating cable is excessively coiled or
kinked.
Make sure the oating cable is spread out over the
pool. Ensure the cable is not too tightly wrapped
or coiled when storing. If the problem persists, lay
the cable straight in the sun to relax it and remove
kinks. Follow the procedure in Cord Tangling to
avoid and correct tangled cord.
To Next Page
Loading...
Need help?
General
