24
7. Return-to-Base button
8. Main mode start/stop button
9. Cleanup schedule mode
10. Wall-along cleanup mode
11. Suction power increase mode "Maximum"
DELIVERY SET
1. Robotic vacuum cleaner assembly - 1 pc.
2. Dust bag (installed) - 1pc.
3. Accumulator (electric battery - installed) - 1 pc.
4. Charging base - 1pc.
5. Charger (adapter) -1 pc.
6. Lateral brushes (not installed): the right - 2 pcs.; the left - 2 pcs.
7. A spare set of HAPA filter and primary filter - 2 pcs.
8. Cleaning brush - 1 pc.
9. Remote control unit - 1 pc.
10. Operation manual - 1 pc.
11. Warranty sheet - 1 pc.
12. Package (polyethylene wrapping + box) - 1 pc.
UNPACKING THE DEVICE AND GETTING STARTED
Open the box, carefully take out the device, remove all the package materials.
Remove any advertising stickers from the device body.
Check the delivery set for completeness (see "Delivery Set" Section).
Take out all the accessories and the charger.
Check all the components for integrity.
Install the lateral brushes. For this, position the vacuum cleaner so that the bottom panel faces upward. Put
each brush on its axis by slightly pressing until a click.
OPERATION
Due to the domestic environment complexity, the vacuum cleaner can miss some tough-to-access areas. To
achieve the best result, it is recommended to use the vacuum cleaner on a daily basis.
Remove any obstacles, toys, and wires from the floor to be cleaned. (Fig. 5)
Use the vacuum cleaner on low-pile carpets only.
Do not stay on the path or at the door aperture during the cleaning, otherwise the vacuum cleaner does not
reach such areas.
Install a barrier if the vacuum cleaner is operated on a half landing
or within a restricted space among furniture. (Fig. 6)
1. Having the dust bag cleaned, and in assembly with the filters, install it into the compartment in the rear
side of the device. Put the vacuum cleaner on the floor so that its control panel faces upward. Set the
switch to "O" position. (Fig. 7)
2. To launch the main program, make a single-shot push on the button on the device or on the remote
control unit. This causes the button glittering. Once the start button illuminates steadily, the vacuum cleaner
starts the room cleaning. (Fig. 8)
3. One more push on the button on the device or button on the control unit causes the cleanup
cessation, and the vacuum cleaner switches to "Pause" mode.
To Next Page
Loading...
Need help?
General
