English
9
6
Check for Proper Wheel RPM
Before operating the cleaner, check for proper wheel revolutions per minute (RPM). For
maximum efficiency, the cleaner should operate between 28 and 32 RPM.
IMPORTANT: Keep the cleaner submerged for accurate wheel speed count.
1. Turn on the filtration pump and allow it to prime.
2. Turn on the booster pump, the cleaner will begin to move.
3. With both pumps on, pull the cleaner to the waterline and keep submerged.
CAUTION: Always lift the cleaner using the handle and take care to avoid possible
hair entanglement when leaning over.
NOTE: The Polaris
®
logo latch is not a handle.
4. Using the Polaris logo on the left-front wheel as a reference, count wheel
revolutions (RPM) for 1 minute. If wheels change direction during timing, start over.
5. Targetwheelspeedis28 to 32 RPM. If wheel speed is not in target range, refer to
Section 7 Adjust Wheel Speed.
Keep cleaner
submerged for accurate
wheel speed count.
To Next Page
Loading...
Need help?
General
