37
OPERATION
Driving Procedure
1. Wear a helmet, eye protection,
gloves, long-sleeve shirt, long
pants and over-the-ankle boots.
2. Perform the pre-ride
inspection. See page 35.
3. Sit in the driver's seat and
fasten the seat belt.
4. Always use the cab nets (or
doors) while riding in this
vehicle.
5. Start the engine and allow it to
warm up.
6. Apply the service brakes and
shift the transmission into gear.
7. Check your surroundings and determine your path of travel.
8. Release the park brake.
9. Keeping both hands on the steering wheel, slowly release the brakes and depress the
throttle with your right foot to begin driving.
10. Drive slowly. Practice maneuvering and using the throttle and brakes on level surfaces.
11. Do not carry a passenger until you have at least two hours of driving experience with this
vehicle.
To Next Page
Loading...
Need help?
General
