27
FEATURES AND CONTROLS
Park Brake Lever
To help prevent the vehicle from roll-
ing, engage the park brake when park-
ing the vehicle. When the park brake is
fully engaged, “BRAKE” appears in
the rider information display. Engine
speed is limited to 1300 RPM in all
gears, except neutral. If throttle is
applied, this limiting feature prevents
operation, which protects the park brake pads from excessive wear.
Tip: This feature will not operate properly if the park brake connector or switch
(under the hood) malfunctions or becomes disconnected, or if the switch
has moved. Check for disconnection, then see your dealer promptly if this
feature fails to operate properly.
Inspect and adjust park brake cable tension after the first 25 hours of
operation and every 100 hours thereafter to ensure proper cable tension.
See page 86.
Always apply the service brakes
before engaging or releasing the
park brake.
1. Apply the brakes.
2. Pull the park brake lever
downward as far as possible.
3. To release the park brake,
apply the brakes. Press the
park brake release inward and
move the lever upward as far
as possible.
WARNING! Operating the vehicle while the park brake is engaged could cause
loss of control and result in serious injury or death. Always disengage the park
brake before operating the vehicle.
To Next Page
Loading...
Need help?
General
