60
MAINTENANCE
Vehicle Immersion
NOTICE: If your vehicle becomes immersed, major engine damage can result if the machine is not
thoroughly inspected. Take the vehicle to your dealer before starting the engine.
If it's impossible to take your RANGER to a dealer before starting it, follow the steps outlined
below.
1. Move the vehicle to dry land or at the very least, to water below the footrests.
2. Dry any water present in the air box. Filter replacement is required if water is present.
3. Thoroughly dry the air pre-cleaner located under the hood.
4. Remove the spark plugs. Turn the engine over several times using the electric start.
5. Dry the spark plugs and reinstall, or replace with new plugs.
6. Attempt to start the engine. If necessary, repeat the drying procedure.
7. Take the vehicle to your dealer for service as soon as possible, whether you succeed in
starting it or not.
8. If water has been ingested into the PVT follow the procedure on page 59 for drying.
Filter Systems
Air Filter
Always change the air filter at the intervals outlined in the Periodic Maintenance Chart
beginning on page 43. Service the air filter more frequently if the vehicle is operated in wet
conditions or at high throttle openings for extended periods.
1. Lift the cargo box to access the air
box.
2. Remove the air box cover and inspect
the gasket. It should adhere tightly to
the cover and seal all the way around.
Tip: Grasp the filter end to prevent damage to
the filter paper.
3. Remove the air filter.
4. Do not attempt to clean the main ele-
ment. Install a new air filter.
Tip: Apply a small amount of general purpose
grease to the sealing edges of the filter
before installing.
5. Inspect the air box for oil or water deposits. If present, drain into a suitable container.
Air Filter
To Next Page
Loading...
Need help?
General
