POLARIS VARIABLE TRANSMISSION (PVT)
SYSTEM
WARNING
The PVT system rotates at high speeds, creating large amounts of force on
clutch components. Failure to follow PVT maintenance and belt replacement
instructions can result vehicle damage, loss of control and severe injury or
death:
• Do not modify any component of the PVT system. Doing so may reduce its
strength so that a failure may occur at a high speed. The PVT system has
been precision balanced. Any modification will cause the system to be out of
balance, creating vibration and additional loads on components.
• Always look for and remove debris inside and around the clutch and vent
system when replacing the belt.
• Always make sure the PVT housing is securely in place during operation for
the safety of riders and bystanders.
• This PVT system is intended for use on POLARIS products only. Do not
install it in any other product.
Always follow all recommended PVT maintenance and belt replacement
procedures. An authorized POLARIS dealer can perform any service that may
be necessary for your vehicle
Belt slip is responsible for creating excessive heat that destroys belts, wears
clutch components and causes outer clutch covers to fail. Switch to low range
while operating at slower speeds to extend the life of the PVT components (belt,
cover, etc.).
111
MAINTENANCE
To Next Page
Loading...
Need help?
General
