6. Add the recommended fluid (listed in the Gearcase Specification Chart) to
the bottom of the fill plug hole. Do not overfill.
7. Reinstall the fill plug. Torque to specification (listed in the Gearcase
Specification Chart).
8. Check for leaks. Discard used fluid properly.
FRONT GEARCASE
Always check and change the fluid at the intervals outlined in the Periodic
Maintenance Chart section. Refer to the Gearcase Specifications Chart for
recommended lubricants, capacities and torque specifications.
FLUID CHECK
The fill plug
q
is located on the bottom right side of the front drive unit. Maintain
recommended fluid volume (listed in the Gearcase Specification Chart).
1. Position the vehicle on a
level surface.
2. Remove the fill plug using an
8 mm Allen wrench.
3. Check the fluid level.
4. Add the recommended fluid
(listed in the Gearcase
Specification Chart). Do not
overfill.
5. Reinstall the fill plug. Torque
to specification (listed in the
Gearcase Specification
Chart).
97
MAINTENANCE
To Next Page
Loading...
Need help?
General
