FILTER SYSTEMS
INTAKE PRE-FILTERS
The engine intake pre-filter
q
is located on the right side of the vehicle. The
clutch air intake
w
is located on the left side of the vehicle.
Inspect the engine pre-filter before each use of the vehicle to ensure adequate
air flow. If necessary, remove the pre-filter and clean with soapy water. Dry with
low pressure compressed air.
Periodically inspect the clutch (PVT) air intake for debris and clean as needed to
ensure adequate air flow.
TIP
When washing the vehicle, always avoid spraying water directly toward the
PVT intake duct. See the Washing the Vehicle section for recommended
washing procedures.
AIR FILTER
Always change the air filter at the intervals outlined in the Periodic Maintenance
Chart.
1. Remove the cargo box access panel.
2. Clean all dirt and debris from the air box area.
152
MAINTENANCE
To Next Page
Loading...
Need help?
General
