125
MAINTENANCE AND LUBRICATION
Minor Maintenance
Flushing Procedure
Flushing the cooling system with fresh water is necessary to neutralize
the corroding effects of salt water or water with impurities like silt,
sand, alkali and other particles as well as to flush out other residue left
in the water passages of the watercraft cooling system.
Flush water passages when the watercraft is not going to be ridden
again that day or if the watercraft is expected to be stored for an
extended time.
Use Flush Kit PN 2871443.
1. Attach garden hose to Female Coupler/Hose attachment
2. Snap the male and female together coupler
3. Snap the male and female together coupler
4. Start watercraft engine.
5. immediat ely turn on the water faucet
6. Rev the engine intermittently for one minute to completely flush
the cooling system.
7. Turn off the water faucet.
8. When all water has exited the cooling system, turn off the
watercraft engine. NOTE: This step should not take longer than
10 seconds.
9. Press button on female coupler/hose attachment to separate from
male coupler.
To Next Page
Loading...
Need help?
General