Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with Class B limits
in Subpart B of Part 15 of the FCC rules.
Do not make any changes or modifications to the equipment
unless otherwise specified in the manual. If such changes or
modifications should be made, you could be required to stop
operation of the equipment.
Notice: If static electricity or electromagnetism causes data
transfer to discontinue midway (fail), restart the application
or disconnect and connect the communication cable (USB,
etc.) again.
Electronic Waste
PLR IP Holdings, LLC, its licensees and affiliates, fully supports
all electronic waste initiatives. As responsible stewards of
the environment, and to avoid violating established laws, you
should properly dispose of this product in compliance with all
applicable regulations, directives or other governances in the
area where you reside. Please check with local authorities or
the retailer where you purchased this product to determine
To Next Page
Loading...
Need help?
General
