Why does my Polycom VSX start in the software update screen?
If your Polycom Conference System starts in the software update screen, it may be because the power switch was pressed for too long (VSX 7000e, VSX 8000). To power up the system, press and release the power button. Alternatively, the system software might be corrupted or not loaded properly, so try loading the system software from your computer.
What to do if my Polycom VSX Conference System does not start?
If your Polycom Conference System doesn't start, check the following: * Ensure the power switch is turned on for the system and all connected equipment. * Verify the power cord is connected to an active power outlet and securely seated. * If using a power strip, confirm it's connected and switched on.
Why does my Polycom Conference System restart over and over?
If your Polycom Conference System restarts repeatedly, it might be due to a loose power plug. Ensure the power plug is securely seated. Another cause could be a corroded socket, in which case you should unplug and reseat the power plug five times.
General| Video Standards | H.264, H.263++ |
|---|---|
| Audio Standards | G.711, G.722, G.722.1, G.728 |
| Network Protocols | H.323, SIP |
| Video Inputs | S-Video, Composite video |
| Video Outputs | Composite, S-Video, DVI, HDMI |
| Audio Inputs | Line In |
| Audio Outputs | Line Out |
| Data Collaboration | H.239 |
| Network Interfaces | Ethernet |
| Power Consumption | Varies depending on the specific model and configuration. |
To Next Page
