OWNER′S MANUAL
3
OPERATING INSTRUCTIONS
1. Loosen the screw of the battery cover with a screwdriver (not included).
BATTERY REPLACEMENT OF REMOTE CONTROL
2. Replace the used battery with a new CR2032 button cell battery (not included). Make sure that the battery is installed with the correct polarity (+ and -).
3. Retighten the screw to close and secure the battery cover.
You can customize the light functions by using either the Light Controller or the Remote Control.
1. Before using the remote control, remove the insulation tab on its rear.
2. Press the Selector Button once on either control and wait for a second to enjoy light effects in the pre-programmed sequence.
Fuse Replacement:
1. Grasp the plug and unplug the product from power. Do not unplug by pulling on the cord.
2. Slide open the fuse cover and remove the blown fuse carefully.
3. Insert the included spare fuse.
Risk of fire: replace only with 10 Amp 125 Volt fuse provided with the product.
4. Close the fuse cover.
1. This product is powered by a lithium battery. Due to their small size, lithium batteries can easily be swallowed by children. Ingestion of such
batteries has been known to cause death.
2. This is a lithium battery which if swallowed has been known to cause death.
3. Do not expose light set to moisture.
4. Remove batteries when not used for an extended period of time, or when depleted.
5. Dispose of used batteries properly.
6. Use only CR2032 batteries for the remote controller.
7. Clean the battery contacts prior to battery installation.
8. Do not dispose of batteries in fire. Batteries may explode or leak.
9. Small parts, keep batteries out of reach of children.
WARNING
SPARE FUSE
10A
Insulation Tab
Cover
Battery
CR2032
To Next Page
Loading...
Need help?
General