1. Introduction And Intended Applications
This innovative battery isolator is the only one in the market with separate settings
for disconnect and reconnect voltages.
The independent settings of voltages cover a much wider and precise application
requirement and types of batteries.
Intended Applications:
caravan, car with second battery, solar /wind charging multiple battery banks and
battery over discharge or over charge.
This unit when used between two batteries, it functions as an isolator as following:
● It isolates the main (starting) battery from the second battery in normal
condition.
● It allows charging of the second battery only when the main battery is at the
selected voltage level set in LVR (Connect).
This way , it also diverts excess power from the alternator to run equipment that
feeds from the second battery.
It does not allow the second battery to power the car electronics or feed into the
starting of the car unless the manual Over-Ride Connection is activated .
It prevents excessively large charging current dumping into the depleted second
battery from the main battery.
When used with one battery
When it is used with one battery and a load , it acts as a low voltage cut off to keep
the battery from over discharge according to the selected voltages settings.
To Next Page
Loading...
Need help?
General