PowerTech PTRV- 8 KSI User Manual

ENGINE OIL MAINTENANCE
Ambient Temperature Oil Viscosity
Above 25°C (77°F)
SAE 10W-30
SAE 30 or
SAE 10W-40
0 to 25°C (32° to 77°F)
SAE 10W-30
SAE 20 or
SAE10W-40
Below 0°C (32°F)
SAE 10W-30
SAE 10W or
SAE 10W-40
8
CHECKING ENGINE OIL LEVEL
( Y ) “ADD” mark. ( X ) “FULL” mark.
1. Maintain the engine oil level between “ADD”
mark and “FULL” mark on oil level gauge.
Do not fill crankcase above “FULL” mark.
2. Remove the oil filler cap and add oil, if
necessary. Clean the oil filler cap. Install the oil
filler cap.
The refill capacities for the engine crankcase
Reflect the approximate capacity of the
crankcase or sump plus a standard oil filter.
Auxiliary oil filter systems will require
additional oil.
KUBOTA ENGINE
REFILL CAPACITIES
D-1105
Crankcase Oil Sump 5.38Qts. (5.1L)
and Filter
V-1505
6.34Qts. (6.0L)
LUBRICATING OIL VISCOSITY
RECOMMENDATIONS
The minimum ambient temperature during cold
engine start-up and the maximum ambient
temperature during engine operation determine the
proper SAE viscosity grade of oil.
Refer to the Engine Oil Viscosity Table below
(Minimum Temperature) in order to determine the
required oil viscosity for starting an engine in cold
conditions.
Refer to the Engine Oil Viscosity Table below
(Maximum Temperature) in order to select the oil
viscosity for engine operation at the highest ambient
temperature that is anticipated.
LUBRICATING OIL
SPECIFICATION
Use only good quality
lubricating oil, which meets
or exceeds of the following
Specification
API-CD
or
Higher

PowerTech PTRV- 8 KSI Specifications

General

Brand	PowerTech
Model	PTRV- 8 KSI
Category	Portable Generator
Language	English