2
PM-1030V v5 2020-10 Copyright © 2020 Quality Machine Tools, LLC
PM-1030V
FAQ
This manual contains essential safety advice on the proper setup, operation, maintenance, and service
of the PM-1030V lathe. Failure to read, understand and follow the manual may result in property damage
or serious personal injury.
There are many alternative ways to install and use a lathe. As the owner of the lathe you are solely
responsible for its proper installation and safe use. Consider the material contained in this manual to
be advisory only. Quality Machine Tools, LLC cannot be held liable for injury or property damage during
installation or use, or from negligence, improper training, machine modications or misuse.
This manual describes PM-1030V machines as shipped from late 2017. There may be detail dierences be-
tween your specic machine and the information given here (with little or no impact on functionality). Please
email us if you have questions about any aspect of the manual or your machine (see our website www.preci-
sionmatthews.com for support addresses). Your feedback is welcomed!
This material was originated by Precision Matthews. No portion
of the manual may be reproduced or distributed in any form
without the written approval of Quality Machine Tools, LLC.
Nothing happens
when RUN MOTOR
button pressed
110Vac power connected?
Motor direction switch set to
O = OFF? Set to F or R
E-Stop button pressed down?
Twist to release
Chuck guard up?
Swing it down to close
Fuse on back panel of electrical
box good?
Gear cover in place, LH side of
headstock?
Replace cover to close safety
switch
Everything
else is OK but
the motor still
doesn't run
Fuse on front
panel good?
To Next Page
Loading...
Need help?
General
