8
PM-1030V v5 2020-10 Copyright © 2020 Quality Machine Tools, LLC
Dimensions, approximate overall, incl. stand
(1030V numbers in black, 1022V this color)
Width 52 45 in. x Height 19 in. x Depth 25 in. (full range cross-
slide motion)
Footprint (excluding handles): Width 52 45 in. x Depth 19 in.
Bed length, excluding headstock: 41-1/2 33-3/4 in.
Bed width: 5-1/4 in.
Spindle centerline to machine tray 12 in., to oor (on stand) 42 in.
Weight, approximate: 395 365 lb net, with stand 475 440 lb net
Power requirement 110 Vac, 60 Hz, 1Ø, 12 A max
Motor 1 HP (750 W) dc
Work envelope
Headstock center to tailstock center 30 in. max
Swing over bed 10 in. diameter
Swing over cross-slide 5-1/2 in. diameter
Spindle face to tailstock quill face 32-1/2 in. max
Saddle travel along bed 29-1/4 in.
Cross-slide travel 5 in.
Compound (top slide) travel 3 in.
Drive system DC drive with 2-speed Vee pulleys
Low range, rpm 50 to 1000
High range, rpm 100 to 2000
Saddle drive, thread cutting Leadscrew 8 TPI, 3/4 in. diameter
Inch threads Choice of 37, from 8 to 80 TPI
Metric threads Choice of 21, from 0.35 mm to 3 mm pitch
Saddle / cross-slide drive, turning & facing Worm driven by keyed slot in leadscrew
Turning operations (saddle feed) Choice of feed rates from 0.0025 to 0.014 in./spindle rev
Facing operations (cross-slide feed) Choice of feed rates from 0.0014 to 0.004 in./spindle rev
Spindle
Chuck/faceplate attachment Direct mount
Internal taper MT4
Spindle bore 1 in.
Spindle length, LH end to back of chuck 10-3/4 in. approx.
Spindle length, LH end to chuck face (typical) 13-3/4 in. approx.
Tailstock
Internal taper MT2
Quill 1.175 in. diameter, 2-1/2 in. travel
Work holding
3-jaw chuck, 5 in.
4-jaw chuck, 5 in.
Faceplate 8 in.
Center rest (steady rest) capacity Up to 1-1/2 in. diameter
Follower rest capacity Up to 1 in. diameter
PM-1030V SPECIFICATIONS
To Next Page
Loading...
Need help?
General
