PARTS DESCRIPTION
1. Air outlet
2. Decoration lighting ring
3. LED display
4. ON/off button
5. Air inlet
6. Remote control
Remote control
a) Speed +/-
b) Timer +/-
c) Screen off
d) Light
e) On/off button
This unit has a remote control. Before use, install 2×AAA 1.5V batteries into the remote control. Please refer to
below pictures. If it is not in use for a long time, please take the batteries out of the remote control.
Note: Most functions of the appliance can only be controlled by remote control. If you have lost the remote
control or if it is damaged, please contact our customer service.
OPERATING INSTRUCTIONS
Connect the appliance to a suitable power source. Then press the on/off button in the appliance or buttons in
the remote control to choose your desired functions.
1. ON/off: Press button “ ” to turn the appliance on. The appliance will work in low speed “1”. Press
“ ” again to turn off the appliance.
2. SPEED: Press button “SPEED +/ SPEED -” on the remote control to adjust the speed.
“1”: low wind; “2”: Medium wind; “3”: high wind
3. TIMER: Press button “TIMER-/ TIMER +” on the remote control to set your desired working time from 1h to
9h (increment by 1h). When the set time has elapsed, the fan will be off and under standby condition.
For example: when press “TIMER +” to set timer to 2 hours, “2h” flashing on the display, meanwhile wind
speed can also be adjusted by pressing “SPEED +/ SPEED –“. If press “SPEED +” to increase the wind speed
from 1 to 2, “2h” shows on the display after “2” flashing. The fan will be off and back to standby mode after
2 hours.
When press “TIMER +” to set timer in 9 hours, “9h” flashing on the display, but if you press “TIMER +” once
again, “1” will flash and it means timer function is off. Another pressing of “TIMER +” will start new timer
To Next Page
Loading...
Need help?
General
