OPERATION: FLYING THE DRONE
Pull the throttle left or right,
the drone turns to the left or right.
STARTING THE ENGINE; ENGINE IDLE
1. After synchronizing the drone, press the engine start button to go into
Idle mode. The blades will rotate but the drone will not lift.
TAKE– OFF:
1. Press the take o button, release, and the drone will lift o and over a
few feet o the ground. Then gently advance the throttle to a desired
height and release. The drone will hover at that height.
OR
2. From Idle mode, gently advance the throttle up to a desired height and
release. The drone will hover at that height.
LANDING:
1. Press the landing button to lower the drone to the ground.
OR
2. Push down on the throttle until the drone is on the ground.
Push the direction lever up or down,
the drone ies forward or backward.
Pull the direction lever to the left or right,
the drone banks to the left or right.
8
9
FIRST TIME FLYERS!!! TAKE YOUR TIME! GO SLOW!
Practice hovering until you are comfortable with ight before attempting
any other maneuvers. Make small movements letting the stick return to
the center. If you start to lose control, don’t panic. Just press land.
OPERATION: FLYING THE DRONE
UP
DOWN
BACKWARD
FORWARD
LEFT MOVEMENT RIGHT MOVEMENT
LEFT ROTATION RIGHT ROTATION
NOTE:
- EmergencyShutO:Wheninight,presstheEngine
StopButtonandthedronewillshuto.
* The drone may drift a bit, especially in the rst 30 seconds until the
altitude sensor gets a good x on the position. Some drift is normal.
To Next Page
Loading...
Need help?
General
