Protocol AIR HOVER RACER User Manual

START-UP PROCEDURE
NOTE:
If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Turn on the drone and then place it on an even surface.
2. Turn on the remote.
3. Both indicators on the drone and the remote will flash while they are syncing.
4. Pull the throttle down to sync. You will hear 2 beeps and the lights will go
steady to indicate the drone has synced.
5. Your drone is now synchronized, and in stand-by mode awaiting Engine
Idle command.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the drone, move the throttle and direction sticks to the lower
center corners and release to go into Idle mode. The blades will rotate but the
drone will not lift.
6

Protocol AIR HOVER RACER Specifications

General

Brand	Protocol
Model	AIR HOVER RACER
Category	Drones
Language	English