START-UP PROCEDURE
NOTE:
If after 30 seconds, the remote has not recognized the helicopter, turn off the
controller and repeat Start-Up procedure.
*This helicopter is meant to be flown indoors. Do not operate under direct sun
or strong lighting as it will affect the signal between the remote and helicopter.
Before flying, the helicopter and remote must be turned on in sequence and
synchronized.
1. Turn on the helicopter and place it on an even surface with the nose facing
away from you.
2. Make sure the remote is off. Set the throttle to minimum.
3. Turn the remote on. The power indicator will flash while it is picking up
the helicopter’s signal. The indicator will go steady once it has picked up
the signal.
4. Push the throttle up and then down to sync.
5. The helicopter is now in stand-by mode and ready to fly.
6
To Next Page
Loading...
Need help?
General
