INSTALLING THE BLADE GUARD
If not already installed, install the included blade guards by snapping them in
and tightening the screws. Make sure the blade guards are secure and snug.
NOTE:
Loose blade guards may interfere
with propeller movement and cause
a crash. If the drone crashes, double
check to make sure the blade guard
is not loose. If it is, re-tighten
before flying.
Battery cover
REMOTE BATTERY AND BLADE GUARD INSTALLATION
1. Install batteries carefully.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
Unscrew and remove battery cover from controller. Insert 4 x ‘AA’ batteries
according to indicated polarities. Replace and screw back in battery cover.
4
To Next Page
Loading...
Need help?
General
