START-UP PROCEDURE
NOTE:
1. If after 30 seconds, it has not recognized the drone, turn off the controller
and repeat Start-Up procedure.
Before flying, the drone and transmitter must be turned on in sequence
and synchronized.
1. Turn on the drone. The light on the drone will flash to indicate it’s on. Place
it on an even surface with the drone facing away from you.
2. Turn on the remote control.
3. Push the throttle the down and then release. The remote will beep two times
and the flashing lights on the drone and remote will turn steady to indicate it
has synced.
4. Your drone is now synchronized, and in stand-by mode awaiting Engine
Idle command.
STARTING THE ENGINE; ENGINE IDLE
After synchronizing the drone, move the throttle and direction sticks in to the lower
center corners (silver lines) and release to go into Idle mode. The blades will rotate
but the drone will not lift.
6
To Next Page
Loading...
Need help?
General