18
Sharpen chiselling tools with grinding wheels
(e.g. ceramic bonded corundum wheel) with
a steady supply of water. Standard values
for this are shown in the illustrated instruc-
tions – see fi gure [4]. Take care that no
annealing colouration appears on the cut-
ting edges, otherwise the hardness of the
chiselling tools will be impaired.
10 Maintenance
- The unit should be stored in a dry place
where it is protected against freezing.
- Before any work on the machine itself,
pull the mains plug!
- Always keep the ventilation slots clean.
- The cable may only be replaced in a spe-
cialised electrical workshop qualifi ed to
perform such work.
- Wipe off the accessible plastic parts regu-
larly with a cloth without cleaning agent.
- After heavy use over a long period, the
machine should be taken to a service
location for an inspection and thorough
cleaning.
- Replacing brushes: Worn carbon brush-
es should be replaced by an authorised
customer service organisation.
11 Environmental
Protection / Disposal
Power tools, accessories and packaging
should be sorted for environmental-friendly
recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and elec-
tronic equipment and its incorporation into
national law, power tools that are no longer
suitable for use must be separately collect-
ed and sent for recovery in an environmen-
tal-friendly manner.
12 Warranty
For our tools, we give warranty for material
and production defects in accordance with
the locally applicable legal provisions, but
in any case for at least 12 months. Within
the EU member states, the warranty period
is 24 months (verifi cation through invoice
or delivery note).
Damage caused by, in particular, natural
wear, overloading, incorrect handling, or
damage caused by the operator, or dam-
age caused through use of the equipment
contrary that specifi ed in the Operating In-
structions, or damage which was known at
the time of purchase, is not covered by the
warranty. Furthermore, damage caused by
the use of non-original PROTOOL accesso-
ries and consumable material (e.g. sanding
pads) is also excluded.
Complaints can only be recognised if the
tool is returned while still assembled to the
supplier or an authorised PROTOOL Cus-
tomer Service workshop. Keep the Operat-
ing Instructions, Safety Instructions, Spare
Parts List and purchase receipt in a safe
place. Otherwise the respective, current
warranty condi tions of the manufacturer
shall apply.
Note
Due to continuous research and develop-
ment work, we reserve the right to make
changes to the technical content of this
documentation.
13 Declaration of
Conformity
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization doc-
uments:
EN 55 014-1, EN 55 014-2, EN 60 745-1,
EN 60 745-2-6, EN 61 000-3-2, EN 61 000-3-3
according to the provision of the regula-
tions stipulated in Directive 98/37/EC (until
28 Dec. 2009), 2006/42/EC (from 29 Dec.
2009), 2004/108/EC.
08
Manfred Kirchner
Research and development
Protool GmbH
Wertstr. 20
D-73240 Wendlingen
31.12.2008
To Next Page
Loading...
Need help?
General
