14
For 400 V:
If efficiency of the rundown brake decreases and the
rundown time of cutting tool after switching off is
prolonged, the brake must be readjusted. However,
this adjustment must be carried out by an authorized
service workshop only.
Storage
Packed electric tools may be stored in dry unheated
storerooms with temperatures not dropping below – 5 °C.
Unpacked electric tools shall be stored only in dry
self-contained storerooms with temperatures not dropping
below + 5 °C, where sudden temperature changes are
prevented.
Recycling
After their service life is ended, submit the electric tool,
its accessories and packages to a disposal premise to allow
reusing of the raw materials.
To allow material-sorted recycling, all plastic components
are marked with relevant symbols.
Repairs and servicing
Repairs in the warranty and post-warranty periods are carri-
ed out by the servicing workshops listed in the index of
addresses.
Guarantee
We guarantee appliances in accordance with statutory /
country-specific regulations (proof of purchase by invoice
or delivery note). Damage attributable to normal wear and
tear, overload or improper handling will be excluded from
the guarantee. In case of complaint please send the
maschine, undismantled, to your dealer or the Service
Centre for electric power tools.
Noise/vibration information
Noise and vibration levels measured and determined
according to EN 50144.
For 230 V:
The typical A-weighted noise levels of the electric tool are:
Sound pressure level: 96 dB(A);
Sound power level: 109 dB(A).
Use ear protection!
The typical level of hand-arm vibration is 2,7 m/s
2
.
For 400 V:
The typical A-weighted noise levels of the electric tool are:
Sound pressure level: 86 dB(A);
Sound power level : 99 dB(A).
Use ear protection!
The typical level of hand-arm vibration is less
than 2,5 m/s
2
.
Product conformity declaration
We declare with our full responsibility that this product
complies with the requirements of the following standards:
EN 50144-1, EN 55014-1, EN 55014-2, EN 61000-3-2,
EN 61000-3-3 according to the provisions of the directives
89/336/EEC, 98/37/EC.
Manfred Kirchner
To Next Page
Loading...
General