Repairs and servicing
10
Guarantee
Maintenance and care
Noise/vibration information
Storage
Recycling
Product conformity declaration
GB
Saw band teeth side-set
Sharpening of the saw bands
The width of side-set should be 0,15 - 0,3 mm each
side, depending on the blade thickness, type and
moisture contents of the wood, and must not exceed
half of the saw band width even when cutting wet wood.
Only the upper third of the tooth height should be side-
set, absolute maximum is upper half of the tooth height.
If the side set reaches down too much, the teeth are
stressed excessively at their roots from flexing of the
saw band, abnormal strain appears, the teeth roots
become weakest points of the saw band, and cracks
occurs at the roots of the teeth.
Care is to be taken when filing the saw bands manually
that edges of the file are sufficiently rounded, because
files with sharp edges contribute to formation of cracks.
When grinding machines are used for sharpening, care
must be also taken that the roots of teeth get a good
radius. Make sure that too much material is not taken
off at once, otherwise the tooth tips overheat and
become brittle. Coarse grinding wheels must not be
used, as they create rough surface giving rise to
concentration of stress and crack formation therefore.
After their service life is ended, submit the electric tool,
its accessories and packages to a disposal premise to
allow reusing of the raw materials.
To allow material-sorted recycling, all plastic
components are marked with relevant symbols.
Repairs in the warranty and post-warranty periods are
carried out by the servicing workshops listed in the
index of addresses.
The portable band saw requires practically no
maintenance. The saw requires no additional
lubrication. It is advisable to remove accumulated
sawdust and chips regularly.
Noise and vibration levels measured and determined
according to EN 50144.The typical A-weighted noise
levels of the electric tool are:
Sound pressure level: 90 dB(A);
Sound power level: 103 dB(A).
The typical level of hand-arm vibration is less than
2,5 m/s .
2
We guarantee PROTOOL appliances in accordance
with statutory/country-specific regulations (proof of
purchase by invoice or delivery note).
Damage attributable to normal wear and tear, overload
or improper handling will be excluded from the
guarantee.
In case of compliant please send the machine,
undismantled, to your dealer or the Service Centre for
electric power tools.
Packed electric tools may be stored in dry unheated
storerooms with temperatures not dropping below -5°C.
Unpacked electric tools shall be stored only in dry self-
contained storerooms with temperatures not dropping
below +5°C, where sudden temperature changes are
prevented.
We declare with our full responsibility that this product
complies with the requirements of the following
standards and regulations:
EN 50 144-1, EN 55 144-2-14, EN 55 014-1,
EN 55 014-2, EN 61 000-3-2, EN 61 000-3-3
according to the provisions of the directives
89/336/EEC, 98/37/EC.
Use ear protection!
Manfred Kirchner
To Next Page
Loading...
Need help?
General
