Repairs and servicing
Recycling
Product conformity
declaration
Repairs in the warranty and post-warranty
periods are carried out by the servicing
workshops listed in the index of addresses.
After their service life is ended, submit the
electric tool, its accessories and packages to a
disposal premise to allow reusing of the raw
materials.
To allow material-sorted recycling, all plastic
components are marked with relevant symbols.
We declare with our full responsibility that this
product complies with the requirements of the
following standards and regulations:
according to the provisions of the directives
73/23/EEC, 89/336/EEC.
EN 60 335-1, EN 60 335-2- , EN 55 014-1,
EN 55 014-2, EN 61 000-3-2, EN 61 000-3-3
69
Manfred Kirchner
Warranty
Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation. In
the EU countries, the warranty period for
exclusively private use is 24 months (an invoice
or delivery note is required as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or any
fault acknowledged at the time of purchase, is
not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before being
sent back to the suppliers or to an authorised
customer support workshop. Store the operating
instructions, safety notes, spare parts list and
proof of purchase in a safe place. In addition, the
manufacturer's current warranty conditions apply.
We reserve the right to make changes to the
technical data contained in this information as a
result of ongoing research and development
work.
Note
Maintenance
At hovering without a liquidation or a filtering
bag, it is necessary to remove the upper part of
the vacuum cleaner out of the container with dirt,
find the pull on the bottom part of the container
by touch and the sucked-in material must be
emptied. The collected material must be
liquidated in compliance with the legal provisions
related. Clean the edge of the container with dirt
before you attach the upper part of the vacuum
cleaner back. Switch the vacuum cleaner and
disconnect the supply plug. Wind up the supply
cable and hang it on the holder (Fig. 9). Empty
the container with dirt and clean the vacuum
cleaner.
After you have finished hovering liquids, put
the upper side of the vacuum cleaner
separated in order to let the filter get dry.
The vacuum cleaner should be kept in dry
environment. Unauthorized use should be
prevented.
Storage
Packed electric tools may be stored in dry
unheated storerooms with temperatures not
dropping below - 5°C. Unpacked electric tools
shall be stored only in dry self-contained
storerooms with temperatures not dropping
below + 5°C, where sudden temperature
changes are prevented.
16
To Next Page
Loading...
Need help?
General
