MAINTENANCE
Routine Inspection: Not required except for periodic inspection of the cable and moulding to
ensure that these are neither damaged nor softened by incompatible liquid.
CAUTION
CARE MUST BE TAKEN NOT TO TOUCH THE PRESSURE SENSITIVE
DIAPHRAGM WHILST CLEANING THE PRESSURE PORT. FAILURE TO OBSERVE
THIS PRECAUTION CAN CAUSE IRREPARABLE DAMAGE.
WARRANTY
The Company warrants its products to be free from defects in material and workmanship in
normal use and service for a period of two years from date of shipment. The Company reserves
the right and option to refund the purchase price in lieu of repair or replacement upon evaluation
of the returned original part. Modification, misuse, attempted repair by others, improper
installation or operation shall render this guarantee null and void. The Company makes no
warranty of merchantability or fitness for a part or purpose.
SERVICING
The transducer cannot be repaired locally and if damaged should be returned to ourselves at the
address shown below:
Pulsar Process Measurement Limited
Oak House
Bromyard Road
Worcester
Worcestershire
WR2 5HP
RETURN TO FACTORY
PLEASE NOTE: To comply with Health and Safety requirements, the instrument must be clean
and safe to handle and accompanied by a formal statement to that effect duly signed by an
authorised officer of the Company.
W A R N I N G
* IF INSTRUMENT IS SUBJECTED TO +400°C PLUS
Some instruments use Viton sealant. Above +400°C this material decomposes
producing (amongst others) Hydrofluoric Acid which is extremely corrosive
To Next Page
Loading...
General