11
ASSEMBLY
• Place generator on a level surface.
Remove the crankcase dipstick to ensure you do not overfill the engine.
•
• Insert a funnel into the crankcase dipstick hold and carefully add 4-Cycle engine oil (SAE10W- 30) to empty reservoir
until oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
• Be sure to replace dipstick before attempting to start the engine.
• To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick without rethreading.
Adding / Checking Engine Oil (See fig 3)
You must add oil before first operating this generator. Always check oil level before each
operation.
DO NOT USE E15 OR E85 FUEL IN THIS UNIT. IT IS A VIOLATION OF FEDERAL LAW AND
WILL DAMAGE THE UNIT AND VOID
YOUR WARRANTY.
CAUTION!
Fig 3
10W30 OIL
Fig 4
Unleaded
Gasoline
To Next Page
Loading...
Need help?
General
