EasyManuals Logo
Home>Pulsar>Portable Generator>PGDA70BiSCO

Pulsar PGDA70BiSCO User Manual

Pulsar PGDA70BiSCO
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
12
Operation
NEVER operate the generator inside any building, garage,
basement, crawlspace, shed, or enclosure, including the
generator compartment of a recreational vehicle.
NEVER operate or start the generator in the back of an SUV,
camper, trailer, truck bed (regular sides, flat or other
configuration), under staircases, stairwells, next to walls or
buildings, or in any other location that will not allow for
adequate cooling of the generator or for the proper exit of the
exhaust flow.
DO NOT operate or store the generator in wet weather
conditions such as rain or snow. Using a generator in wet
conditions could result in serious injury or death due to
electrocution.
Generators must have a minimum of 5 feet (1.5 m) of clearance
from all combustible material.
Generators must also have a minimum of 3 feet (91.4 cm) of
airflow clearance on all sides to allow for adequate cooling,
maintenance, and service.
Always place the generator in a well-ventilated area. NEVER
place the generator near air intake vents or where exhaust
fumes could be drawn into occupied or confined spaces.
Always carefully consider wind and air currents when
positioning the generator.
Always allow generators to properly cool before transport or
for storage purposes.
Failure to follow proper safety precautions may result in
personal injury, damage to the generator, and void the
manufacturer's warranty.
WARNING
WARNING
Generator Location
During operation, the muffler and exhaust fumes will become
hot. If there is inadequate cooling space or if the generator is
blocked or enclosed, temperatures can rise quickly and may
lead to a fire.
Starting The Generator
1. Make sure the generator is on a solid, flat, level surface.
2. Disconnect all electrical loads from the generator. Never start or
stop the generator with electrical devices plugged in or turned on.
3. Turn the fuel switch to desired fuel source. When the Switch is
in the Gasoline position, the generator is ready to start with Gasoline.
When the Switch is in the LPG position, the generator is ready to
start with propane.
4. Switch OFF Low Idle
The low idle switch is located next to the push start button on the
panel. Flip the switch down to disable low idle when starting the
generator.
5. Turn the Main Switch ON
Press the main switch up to the start position to start the generator.
LOW IDLE
ON
OFF
MAIN SW.
ON
OFF
STARTING ON GASOLINE STARTING ON LPG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pulsar PGDA70BiSCO and is the answer not in the manual?

Pulsar PGDA70BiSCO Specifications

General IconGeneral
BrandPulsar
ModelPGDA70BiSCO
CategoryPortable Generator
LanguageEnglish

Related product manuals